zwave-js/.config-db/devices/0x023d/dch-01.json
2025-01-10 22:05:04 -08:00

23 lines
1.9 KiB
JSON
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

{
"manufacturer": "Honest Technology Co., Ltd.",
"manufacturerId": "0x023d",
"label": "DCH-01",
"description": "IoT DoorCam",
"devices": [
{
"productType": "0x0043",
"productId": "0x0001",
"zwaveAllianceId": [1693, 1831, 2457]
}
],
"firmwareVersion": {
"min": "0.0",
"max": "255.255"
},
"metadata": {
"inclusion": "This must be done when the DoorCam is in an excluded status, which means that it is not a part of any Z-Wave network; you will know this because the Z-Wave LED will remain on.\nAfter starting the inclusion process on your Z-Wave controller, please do the following:\na. Press & hold the Z-Wave inclusion button for 5 seconds.\nb. When the Z-Wave LED blinks rapidly, release the Z-Wave inclusion button.\nc. The DoorCam will try inclusion for 30 seconds.\nd. If inclusion was successful, the Z-Wave LED will turn off",
"exclusion": "This must be done when the DoorCam is in an included status, which means that it is a part of any Z-Wave network; you will know this because the Z-Wave LED will remain off.\nAfter starting the exclusion process on your Z-Wave Controller, please do the following.\na. Press & hold Z-Wave button for 5 seconds when DoorCam is inclusion status.\nb. When Z-Wave LED blinks with 250ms interval, Release Z-Wave button to try exclusion.\nc. DoorCam will try exclusion for 30sec.\nd. Z-Wave LED will be turned on if exclusion is successful",
"reset": "a. Hold the Z-Wave button for 10 seconds.\n(Z-Wave LED will blink after 5 seconds with 250ms interval then Z-Wave LED will be turned off after another 5 seconds.) \nb. When Z-Wave LED stops blinking after 10 seconds, release Z-Wave button.\nc. When factory reset is successful, LED will be on.\n\nPlease use this procedure only if the network primary controller is missing or inoperable",
"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2457/IoT%20DoorCam_Manual_r03.pdf"
}
}