{
	"manufacturer": "Honest Technology Co., Ltd.",
	"manufacturerId": "0x023d",
	"label": "DCH-01",
	"description": "IoT DoorCam",
	"devices": [
		{
			"productType": "0x0043",
			"productId": "0x0001",
			"zwaveAllianceId": [1693, 1831, 2457]
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"metadata": {
		"inclusion": "This must be done when the DoorCam is in an excluded status, which means that it is not a part of any Z-Wave network; you will know this because the Z-Wave LED will remain on.\nAfter starting the inclusion process on your Z-Wave controller, please do the following:\na. Press & hold the Z-Wave inclusion button for 5 seconds.\nb. When the Z-Wave LED blinks rapidly, release the Z-Wave inclusion button.\nc. The DoorCam will try inclusion for 30 seconds.\nd. If inclusion was successful, the Z-Wave LED will turn off",
		"exclusion": "This must be done when the DoorCam is in an included status, which means that it is a part of any Z-Wave network; you will know this because the Z-Wave LED will remain off.\nAfter starting the exclusion process on your Z-Wave Controller, please do the following.\na. Press & hold ‘Z-Wave’ button for 5 seconds when DoorCam is inclusion status.\nb. When Z-Wave LED blinks with 250ms interval, Release ‘Z-Wave’ button to try exclusion.\nc. DoorCam will try exclusion for 30sec.\nd. Z-Wave LED will be turned on if exclusion is successful",
		"reset": "a. Hold the ‘Z-Wave’ button for 10 seconds.\n(Z-Wave LED will blink after 5 seconds with 250ms interval then Z-Wave LED will be turned off after another 5 seconds.) \nb. When Z-Wave LED stops blinking after 10 seconds, release Z-Wave button.\nc. When factory reset is successful, LED will be on.\n\nPlease use this procedure only if the network primary controller is missing or inoperable",
		"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2457/IoT%20DoorCam_Manual_r03.pdf"
	}
}