23 lines
1.6 KiB
JSON
23 lines
1.6 KiB
JSON
{
|
|
"manufacturer": "Gerber Technology",
|
|
"manufacturerId": "0x0408",
|
|
"label": "GPS-2000",
|
|
"description": "Gerber Prime Switch",
|
|
"devices": [
|
|
{
|
|
"productType": "0x0001",
|
|
"productId": "0x0073",
|
|
"zwaveAllianceId": 3618
|
|
}
|
|
],
|
|
"firmwareVersion": {
|
|
"min": "0.0",
|
|
"max": "255.255"
|
|
},
|
|
"metadata": {
|
|
"inclusion": "1.Set your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.\n2. Press the middle button (button ⑤) three times within 2 seconds intervals and device will enter inclusion mode.\n3. Node ID is included",
|
|
"exclusion": "1.Set your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.\n2. Press the middle button (button ⑤) three times within 2 seconds intervals and device will enter exclusion mode.\n3. Node ID is excluded.",
|
|
"reset": "Use this procedure only in the event that the primary controller is missing or otherwise inoperable.\n1.Press the middle button (button ⑤) four times and hold the button on the 4th time for about 3~10 seconds, then release button.\nThe green LED will light on ⑤ when every pressing and light off when every releasing. User should check LED whether ⑤ it accepted the pressing or not.\n2.IDs will get excluded and all settings will be reset.\nSurround Blue LED will light on at the 4th pressing and 5 seconds later light off. If reset successfully, Surround Blue LED light will flash one time.",
|
|
"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=product_documents/3618/GPS2000%20manual-20190822.pdf"
|
|
}
|
|
}
|