23 lines
2.3 KiB
JSON
23 lines
2.3 KiB
JSON
{
|
|
"manufacturer": "Climax Technology, Ltd.",
|
|
"manufacturerId": "0x018e",
|
|
"label": "CO-8ZW",
|
|
"description": "Carbon Monoxide Detector",
|
|
"devices": [
|
|
{
|
|
"productType": "0x0003",
|
|
"productId": "0x0009",
|
|
"zwaveAllianceId": [1573, 2075]
|
|
}
|
|
],
|
|
"firmwareVersion": {
|
|
"min": "0.0",
|
|
"max": "255.255"
|
|
},
|
|
"metadata": {
|
|
"inclusion": "This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufactures and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.\n- Insert the 3 “AA” batteries into the battery compartment connecting the correct polarity as shown on the battery compartment lid. CO-8 will emit a 2-tone beep.\n- Put the Z-Wave gateway or control panel into Inclusion or Learning mode (please refer to the Z-Wave gateway or control panel manual).\n- Within 1.5 seconds, press the Function Button 3 times. CO-8 will emit a 2-tone beep.\n- Refer to the operation manual of the Z-Wave gateway/Control panel to complete the learn-in process.\n- If the sensor has already been included (learnt) into another Z-Wave Gateway/Control Panel, or if the sensor is unable to be learnt into the current Z-Wave Gateway/Control Panel, please exclude it first (see Exclusion) before attempting to include it into the current Z-Wave Gateway/Control Panel.",
|
|
"exclusion": "The Carbon Monoxide Detector must be removed from existing Z-Wave network before being included into another. There are two methods available to exclude a device.\nExclusion Mode\n- Put the Z-Wave gateway or control panel into Exclusion mode (please refer to the Z-Wave gateway or control panel manual).\n- Within 1.5 seconds, press the Function Button 3 times and the Carbon Monoxide Detector will be removed from the Z-Wave network.",
|
|
"reset": "Factory Reset\n(Only use factory reset when network Control Panel/Gateway is missing or inoperable).\n- Remove the batteries of the Carbon Monoxide Detector first.\n- Press and hold the Test Button. While holding the Test Button, power on the Heat Detector by re-inserting the batteries, wait for 10 seconds to factory reset.",
|
|
"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2075/CO-8ZW_20161109.docx"
|
|
}
|
|
}
|