21 lines
1.5 KiB
JSON
21 lines
1.5 KiB
JSON
{
|
||
"manufacturer": "Eaton",
|
||
"manufacturerId": "0x001a",
|
||
"label": "HOMECT",
|
||
"description": "Eaton’s Home Automation Hub",
|
||
"devices": [
|
||
{
|
||
"productType": "0x0000",
|
||
"productId": "0x0001",
|
||
"zwaveAllianceId": 2637
|
||
}
|
||
],
|
||
"firmwareVersion": {
|
||
"min": "0.0",
|
||
"max": "255.255"
|
||
},
|
||
"metadata": {
|
||
"reset": "If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.\"\n\nFollowing the following steps to reboot the controller and reset network settings:\n1. Locate the recessed push button on the Home automation hub. \n2. Insert the paper clip (provided) pressing the button down and holding for 20 seconds.\n3. Remove the paper clip and observe the LED behavior. The Home automation hub’s LED indicators alternate red and blue signifying it has entered the reboot state. \n4. Once the Home automation hub boots and the LED flashes red in .5 second intervals, it is in AP mode. Now continue with re-installation and setup.",
|
||
"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2637/User%20manual%20and%20Quick%20Start%20Guide.pdf"
|
||
}
|
||
}
|