Z-Wave application framework API version


Z-Wave application framework API build number


Delay time after the plug is switched off


Threshold at which the plug enters overcurrent protection mode


Change in current consumption that triggers a report


Threshold at which the plug sends an overcurrent notification


On/Off report (Dry contact switch/sensor)

Garage door mode (Momentary mode) for relay and door sensor (Open/Close) for input

Note: The device must be excluded (without resetting it) and re-included after changing to/from values 4-11


Select the same value as you chose for parameter 2 to reverse the values for open and closed circuit


Select the same value as you chose for parameter 3 to reverse the values for open and closed circuit


If disabled and Parameter 2 is >= 4, a Z-Wave report will be sent but R1 will not be triggered


If disabled and Parameter 3 is >= 4, a Z-Wave report will be sent but R2 will not be triggered


Sync R1 and R2 together to prevent both being activated at the same time


Sets the duration of an on/off period in 1/10th seconds. Must be set together with "On/Off Cycle Count"


Sets the number of on/off periods. 0xff means infinite. Must be set together with "On/Off Period duration"


This property is used to set the length of the On time during an On/Off period. It allows asymmetric On/Off periods. The value 0x00 MUST represent symmetric On/Off period (On time equal to Off time)


Button 1 indication - On/Off Period: Duration


Button 1 indication - On/Off Cycle Count


Button 1 indication - On/Off Period: On time


Button 2 indication - On/Off Period: Duration


Button 2 indication - On/Off Cycle Count


Button 2 indication - On/Off Period: On time


Button 3 indication - On/Off Period: Duration


Button 3 indication - On/Off Cycle Count


Button 3 indication - On/Off Period: On time


Button 4 indication - On/Off Period: Duration


Button 4 indication - On/Off Cycle Count


Button 4 indication - On/Off Period: On time


Button 5 indication - On/Off Period: Duration


Button 5 indication - On/Off Cycle Count


Button 5 indication - On/Off Period: On time


Send Report and Toggle LED on Button Press If Relay Disabled


Controls programming (eg. including/excluding) device through physical inputs, allowing the according input sequence to be used for scene control instead. Factory reset remains available.


Send Status Change Report: Local Control

Determine whether a trigger of this type should prompt a status change report to associated devices.


Z-Wave application framework API version


Z-Wave application framework API build number


Button 1 indication - On/Off Period: Duration


Button 1 indication - On/Off Cycle Count


Button 1 indication - On/Off Period: On time


Button 2 indication - On/Off Period: Duration


Button 2 indication - On/Off Cycle Count


Button 2 indication - On/Off Period: On time


Button 3 indication - On/Off Period: Duration


Button 3 indication - On/Off Cycle Count


Button 3 indication - On/Off Period: On time


Button 4 indication - On/Off Period: Duration


Button 4 indication - On/Off Cycle Count


Button 4 indication - On/Off Period: On time


Button 5 indication - On/Off Period: Duration


Button 5 indication - On/Off Cycle Count


Button 5 indication - On/Off Period: On time


Send Report and Toggle LED on Button Press If Relay Disabled


Send Status Change Report: Local Control


Z-Wave application framework API version


Z-Wave application framework API build number


Press two times ON and two times OFF, LED will flash 5 times if successful


Reverse the default On/Off rocker setting


Which outside handles can open the door (configuration)


Which inside handles can open the door (configuration)


Which outside handles can open the door (actual status)


Which inside handles can open the door (actual status)


Number of wrong attempts before the lockout a triggered