// 800 series (LR) starting with firmware 2.0
{
	"manufacturer": "Zooz",
	"manufacturerId": "0x027a",
	"label": "ZSE18",
	"description": "Motion Sensor",
	"devices": [
		{
			"productType": "0x0301",
			"productId": "0x0012"
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"paramInformation": [
		{
			"#": "12",
			"$import": "templates/zooz_template.json#motion_sensitivity_1_8",
			"defaultValue": 4
		},
		{
			"#": "14",
			"$import": "~/templates/master_template.json#base_enable_disable",
			"label": "Motion Detection: Send Basic Set",
			"defaultValue": 1
		},
		{
			"#": "15",
			"$import": "templates/zooz_template.json#basic_set_value"
		},
		{
			"#": "17",
			"$import": "~/templates/master_template.json#base_enable_disable",
			"label": "Vibration Sensor",
			"defaultValue": 1
		},
		{
			"#": "18",
			"label": "Motion Detection: Timeout",
			"description": "3 seconds are added to the configured value (e.g. 27 equals 30 seconds)",
			"valueSize": 2,
			"unit": "seconds",
			"minValue": 3,
			"maxValue": 65535,
			"defaultValue": 27,
			"unsigned": true
		},
		{
			"#": "19",
			"$import": "templates/zooz_template.json#binary_sensor_report"
		},
		{
			"#": "20",
			"$import": "~/templates/master_template.json#base_enable_disable",
			"label": "Flash LED on Motion",
			"defaultValue": 1
		},
		{
			"#": "32",
			"$import": "templates/zooz_template.json#low_battery_alarm_threshold",
			"defaultValue": 10
		}
	],
	"metadata": {
		"wakeup": "Press and HOLD the Z-Wave button for 5 seconds to wake the device up. The LED will start flashing.",
		"inclusion": "1. Bring the sensor within direct range of your Z-Wave gateway (hub).\n2. Put the Z-Wave hub into inclusion mode.\n3. Press and release the Z-Wave button 3 times quickly. The LED indicator will start blinking fast and turn solid for a second to confirm inclusion.",
		"exclusion": "1. Bring the sensor within direct range of your Z-Wave gateway controller (hub).\n2. Put the Z-Wave hub into exclusion mode.\n3. Press and release the Z-Wave button on the sensor 3 times as quickly as possible.\n4. Your hub will confirm exclusion and the device will disappear from your controller's device list.",
		"reset": "To complete the reset process manually, press and HOLD the Z-Wave button on the sensor for at least 20 seconds. The LED indicator will flash, stay solid, and then turn off to confirm factory reset.",
		"manual": "https://www.getzooz.com/downloads/zooz-z-wave-plus-motion-sensor-zse18-manual.pdf"
	}
}