{
	"manufacturer": "Ningbo Sentek Electronics Co., Ltd.",
	"manufacturerId": "0x0185",
	"label": "ZM-800",
	"description": "PIR Motion Sensor",
	"devices": [
		{
			"productType": "0x0003",
			"productId": "0x0009",
			"zwaveAllianceId": [1733, 1803]
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"paramInformation": [
		{
			"#": "1",
			"label": "LED Light",
			"valueSize": 1,
			"defaultValue": 1,
			"allowManualEntry": false,
			"options": [
				{
					"label": "Disable",
					"value": 0
				},
				{
					"label": "Enable",
					"value": 1
				}
			]
		}
	],
	"metadata": {
		"inclusion": "1. Make sure ZM-800 is in the range of the Z-Wave controller. \n2. Set the Z-Wave controller to the inclusion mode. \n3. Quickly pressing TP-Switch2 button 3 times on the ZM-800.\n4. The ZM-800 is added to the network",
		"exclusion": "1. Make sure ZM-800 is in the range of the Z-Wave controller. \n2. Set the Z-Wave controller to the exclusion mode. \n3. Quickly pressing TP-Switch2 button 3 times on the ZM-800.\n4. The ZM-800 is deleted from the network",
		"reset": "Note: Use the reset procedure only in the event that the network primary controller is missing or otherwise inoperable.\n1. Press the TP-Switch2 button more than 5 seconds. \n2. Z-Wave LED is start blinking.\n3. Release the TP-Switch2 button right now.\n4. Z-Wave LED off, reset is performed"
	}
}