{ "manufacturer": "Willis Electric Co., Ltd.", "manufacturerId": "0x015d", "label": "ZEN21", "description": "Zooz Z-Wave On / Off Light Switch", "devices": [ { "productType": "0x0111", "productId": "0x231c", "zwaveAllianceId": 1945 } ], "firmwareVersion": { "min": "0.0", "max": "255.255" }, "metadata": { "inclusion": "1. Bring your Z-Wave gateway hub or controller as close to the switch as possible\n2. Put your Z-Wave controller in inclusion mode\n3. Tap the switch on and off quickly 3 times to finalize the inclusion process\n4. A new on/off device should appear on your controller's device list\n\nTroubleshooting Tips:\nIf you are unable to include the Z-Wave switch to your controller, please try one of the following:\n- Bring the controller closer to your Z-Wave switch or use a hand-held secondary controller for inclusion\n- Tap your Z-Wave switch quicker 4 or 5 times once you put the controller in the inclusion mode to ensure the command has gone through\n- Put your controller in the EXCLUSION mode and tap the switch quickly 3 times, then try adding it to your network again", "exclusion": "1. Bring your Z-Wave gateway hub or controller as close to the switch as possible\n2. Put your Z-Wave controller in exclusion mode\n3. Tap the switch on and off quickly 3 times to complete the exclusion process\n4. The device should disappear from your controller's device list\n\nPlease repeat the process following all steps carefully if the first attempt is unsuccessful", "reset": "The switch will be reset to factory defaults only by exclusion using a Z-Wave controller. You may use any certified Z-Wave controller to exclude and reset the switch. This device may not be reset manually when the network’s primary controller is missing or otherwise inoperable. NOTE: All previously recorded activity and custom settings will be erased from the device’s memory", "manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/1945/zooz-z-wave-plus-on-off-switch-zen21-manual.pdf" } }