{
	"manufacturer": "Fakro",
	"manufacturerId": "0x0085",
	"label": "ZWS12",
	"description": "Chain Actuator - Window Opener",
	"devices": [
		{
			"productType": "0x0002",
			"productId": "0x0011",
			"zwaveAllianceId": 2477
		},
		{
			"productType": "0x0002",
			"productId": "0x0111"
		},
		{
			"productType": "0x0002",
			"productId": "0x0116"
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"paramInformation": [
		{
			"#": "7",
			"label": "Motor Speed I",
			"valueSize": 1,
			"minValue": 1,
			"maxValue": 4,
			"defaultValue": 2
		},
		{
			"#": "8",
			"label": "Motor Speed II (Rain Sensor)",
			"valueSize": 1,
			"minValue": 1,
			"maxValue": 4,
			"defaultValue": 2
		},
		{
			"#": "12",
			"$import": "templates/fakro_template.json#calibration"
		},
		{
			"#": "13",
			"$import": "templates/fakro_template.json#shutter_response_to_basic_set_0xff"
		},
		{
			"#": "15",
			"label": "Close After Time",
			"valueSize": 1,
			"unit": "minutes",
			"minValue": 0,
			"maxValue": 120,
			"defaultValue": 0
		}
	],
	"metadata": {
		"inclusion": "Autoinclusion - This feature allow you to add hard to reach devices to Z-Wave network. 3-times ON and OFF the power actuator (OFF-ON-OFFON-OFF-ON) causes the introduction of actuator to Autoinclusion mode.\nPlease note that the procedure has been started the time between on and off can not exceed 20s. Autoinclusion mode is activated for a maximum of 10 minutes. During this time, we can add an actuator to any Z-Wave controller running in the Include procedure.\n\nInclude - This function allow you to add actuator to the network Z-Wave.\nFollow the procedure adding device to the network Z-Wave according to user manual supplied with the product. Then, press the programming button P on the actuator for 1 second",
		"exclusion": "Exclude - This function allow you to remove actuator from the network Z-Wave. Follow the procedure removing device from the network Z-Wave\naccording to user manual supplied with the product. Then, press the\nprogramming button P on the actuator for 1 second. Function removes\ninformation only about network Z-Wave",
		"reset": "Device Reset Locally – This function allows you to reset the Z-Wave\nnetwork without the use of Z-Wave controller. Press 5 times the\nprogramming button P fast, the actuator was removed from the Z-Wave\nnetwork, restore the default parameters, name and locations. \nPlease use this procedure only when the network primary controller is missing or otherwise inoperable",
		"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2477/170511%20ZWS12%20User%20Manual.pdf"
	}
}