{
	"manufacturer": "2KLIC",
	"manufacturerId": "0x0369",
	"label": "7440-MC-FS",
	"description": "Connectair Module",
	"devices": [
		{
			"productType": "0x0100",
			"productId": "0x0101",
			"zwaveAllianceId": 2965
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"metadata": {
		"inclusion": "Start the adding process on the controller side\n\nOnce started, start the adding process on the Connectair module by pressing 3 times the Z-Wave button, located between the plus and the minus button, using the included tool.\n\nWhen added, the LED will turn off",
		"exclusion": "Start the removing process on the controller side\nOnce started, put the device in \"learn mode\" by pressing 3 times on the Z-Wave button, located between the plus and the minus button, using the included tool.\nWhen removed, the LED will turn on",
		"reset": "Please use this procedure only when the network primary controller is missing or otherwise inoperable\n\nHold the Z-Wave button for about ten seconds\nIf it was included, the LED will turn back on when reset is done",
		"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2965/ICCVUG-120618-2329.pdf"
	}
}