{
	"manufacturer": "Hoppe",
	"manufacturerId": "0x0313",
	"label": "FG-FR404-ZW-HF",
	"description": "Wireless Handle",
	"devices": [
		{
			"productType": "0x0001",
			"productId": "0x0001",
			"zwaveAllianceId": 2089
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"metadata": {
		"inclusion": "A Z-Wave network controller in Z-Wave terminology can be connected to the handle. If you want to use a Z-Wave network controller, you must add the handle to the network. Proceed as follows:\n1. Set the receiver to the inclusion mode\n2. With the window open, change the handle position at least six times within three seconds, causing the green LED to flash continuously;\n3. The handle should now be added to the Z-Wave network.\n4. The green LED flashes once (1 second) when the handle is included",
		"exclusion": "To remove the handle from your Z-Wave network, do the following:\n1. Open the window / door.\n2. Set the Z-Wave controller to the Exclude mode;\n3. With the window open, change the handle position at least six times within three seconds, causing the green LED to flash continuously;\n4. The handle should now be removed from the Z-Wave network.\n5. The red LED flashes once (1 second) if the handle has been successfully excluded.",
		"reset": "Open the handle. Change window / door position at least 6 times, stopping when the window / door is open. Change the handle position at least 6 times. All this should be completed within 10 seconds.\nImportant: Use this procedure only if the primary network controller is missing or otherwise inoperable.",
		"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2089/Manual_Wirelesshandle_V10_gb.pdf"
	}
}