{
	"manufacturer": "SATCO Products, Inc.",
	"manufacturerId": "0x0307",
	"label": "86-100",
	"description": "Z-Wave Plug-In On/Off Appliance Module",
	"devices": [
		{
			"productType": "0x4447",
			"productId": "0x3031",
			"zwaveAllianceId": 2042
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"paramInformation": [
		{
			"#": "3",
			"label": "LED Indicator",
			"description": "The LED indicator will be on whenever the connected appliance is off, and turns off when the connected device is on",
			"valueSize": 1,
			"defaultValue": 0,
			"allowManualEntry": false,
			"options": [
				{
					"label": "LED on when load is on",
					"value": 0
				},
				{
					"label": "LED on when load is off",
					"value": 1
				},
				{
					"label": "Always off",
					"value": 2
				}
			]
		}
	],
	"metadata": {
		"inclusion": "1. Put your network controller into inclusion mode following the instructions from your controller manufacturer\n2. When the controller is ready, single click the button on the front of 86-100 \n3. The controller should indicate that the new device was added successfully",
		"exclusion": "1. Put your network controller into exclusion mode following the instructions from your controller manufacturer\n2. When the controller is ready, single click the button on the front of 86-100 \n3. The controller should indicate that the device was excluded successfully",
		"reset": "Use this procedure only in the event that the network primary controller is lost or otherwise inoperable.\n\na. Unplug 86-100 from the AC outlet and also unplug the power plug of the appliance from the module(if plugged in)\nb. Press and hold the button on the 86-100 module\nc. Plug the 86-100 back into the AC outlet with the button pressed\nd. After 3 seconds, release the button. If you see the button blinks, that means the module has been reset successfully",
		"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2042/86-100%20IOT%20OM_102116.pdf"
	}
}