{
	"manufacturer": "Heatit",
	"manufacturerId": "0x019b",
	"label": "Z-Smoke 230V",
	"description": "Wired Smoke Detector",
	"devices": [
		{
			"productType": "0x0003",
			"productId": "0x3601",
			"zwaveAllianceId": 3933
		},
		{
			"productType": "0x0003",
			"productId": "0x000d"
		},
		{
			"productType": "0x0003",
			"productId": "0x0017"
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"associations": {
		"1": {
			"label": "Lifeline",
			"maxNodes": 1,
			"isLifeline": true
		},
		"2": {
			"label": "Smoke Sensor (Basic Set)",
			"description": "When the smoke detector is active, it will send Basic Set (0xFF) to this group. When the smoke detector is deactivated, it will send Basic Set (0x00).",
			"maxNodes": 5
		}
	},
	"metadata": {
		"inclusion": "Please refer to your primary controller manual on how to enter add/remove mode. The device may only be added or removed from the network if the primary controller is in add/remove mode, and may now be added to the system via the primary controller",
		"exclusion": "Please refer to your primary controller manual on how to enter add/remove mode. The device may only be added or removed from the network if the primary controller is in add/remove mode, and may now be added to the system via the primary controller",
		"reset": "After the calibration process is finished, you may access the add/remove mode by pressing the function button three times within 1.5 seconds. Removing the device will reset it to factory defaults",
		"manual": "https://media.heatit.com/709"
	},
	"compat": [
		{
			"$if": "firmwareVersion >= 4.2.0",
			// Firmware 4.2.0 removed the Binary Switch CC in favor of Basic CC
			// However since this is a sensor, Basic CC values are not offered automatically
			"commandClasses": {
				"add": {
					"Basic": {
						"version": 1,
						"isSupported": true
					}
				}
			}
		}
	]
}