{
	"manufacturer": "Wink Inc.",
	"manufacturerId": "0x017f",
	"label": "D/W SENSOR",
	"description": "Door/Window Sensor",
	"devices": [
		{
			"productType": "0x0100",
			"productId": "0x0001",
			"zwaveAllianceId": 2494
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"paramInformation": [
		{
			"#": "1",
			"label": "Basic Set Off Delay",
			"valueSize": 2,
			"unit": "seconds",
			"minValue": 0,
			"maxValue": 65535,
			"defaultValue": 30,
			"unsigned": true
		},
		{
			"#": "2",
			"label": "Basic Set Level",
			"description": "Allowable range: 0-99, 255",
			"valueSize": 1,
			"minValue": 0,
			"maxValue": 255,
			"defaultValue": 99,
			"unsigned": true,
			"options": [
				{
					"label": "Off",
					"value": 0
				},
				{
					"label": "On",
					"value": 255
				}
			]
		}
	],
	"metadata": {
		"inclusion": "Follow the instructions for your Z-Wave certified Controller to enter inclusion mode.\nWhen prompted by the Controller:\n1. For proper inclusion, bring the Door/Window Sensor within range of your Controller.\n2. Pull the battery tab on the backside of the sensor to power on, or remove then re-install the batteries. The LED light should blink",
		"exclusion": "Follow the instructions for your Z-Wave certified Controller to enter exclusion mode. When prompted by the Controller:\n1. Press the sensor cover release button to remove the top cover, and be sure the sensor is powered on.\n2. Press the Connect Button next to the battery quickly 3 times in a row.\n\nThe LED indicator will flash five times indicating exclusion/disconnection",
		"reset": "If needed, the Door/Window Sensor can be reset locally by following these steps. Only do this when your Z-Wave controller is disconnected or otherwise unreachable. Beware that resetting your device will disconnect it from the system:\n1. Remove the SENSOR COVER and confirm that your Door/Window Sensor is powered up.\n2. Press and hold the BUTTON for at least 10 seconds then release. A flashing light indicates a successful factory reset.\n3. The Door/Window Sensor’s memory will be erased to factory settings",
		"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2494/Wink-Door-Sensor-Manual.pdf"
	}
}