{
	"manufacturer": "Ecolink",
	"manufacturerId": "0x014a",
	"label": "DLS-ZWAVE5",
	"description": "Z-Wave Plus Single Gang Decora Wireless Light Switch",
	"devices": [
		{
			"productType": "0x0006",
			"productId": "0x0001",
			"zwaveAllianceId": 2164
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"associations": {
		"2": {
			"label": "Group 2",
			"maxNodes": 5,
			"isLifeline": true
		}
	},
	"metadata": {
		"inclusion": "The Z-Wave Plus Decora Light Switch must be added to a Z-Wave Plus network prior to use. To include the device in a network both the device and the network controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode. \n\n1) Verify that the Z-Wave Plus controller you are using is compatible with the Z-Wave Plus Decora Light Switch.\n2) Locate the light switch desired to be used with the Z-Wave Plus Decora Light Switch.\n3) Put your Z-Wave Plus Controller into add (inclusion) mode.\n4) Press the inclusion button on the Z-Wave Plus Decora Light Switch. (Figure 1)\n5) The LED on the front of the unit will turn off if successfully included into a network.",
		"exclusion": "1) Any Z-Wave Plus Device can be removed from any Z-Wave Plus controller. Follow the directions to put your Z-Wave Plus Controller into exclusion mode.\n2) Press the inclusion / exclusion button on the Z-Wave Plus Decora Light Switch.",
		"reset": "The Z-Wave Plus device is automatically factory defaulted when removed from a Z-Wave Plus network. Please use this procedure only when the network primary controller is missing or otherwise inoperable.",
		"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2164/Ecolink%20Decora%20Light%20Switch%20Z-Wave%20Plus%20Manual.pdf"
	}
}