{
	"manufacturer": "Leviton",
	"manufacturerId": "0x001d",
	"label": "ZW4SF",
	"description": "4 Speed Fan Controller",
	"devices": [
		{
			"productType": "0x0038",
			"productId": "0x0002",
			"zwaveAllianceId": 3832
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"paramInformation": [
		{
			"#": "3",
			"$import": "~/templates/master_template.json#minimum_dim_level_1-99",
			"defaultValue": 10
		},
		{
			"#": "4",
			"$import": "~/templates/master_template.json#maximum_dim_level_0-100"
		},
		{
			"#": "5",
			"$import": "templates/leviton_template.json#preset_level"
		},
		{
			"#": "6",
			"$import": "templates/leviton_template.json#led_timeout"
		},
		{
			"#": "7",
			"$import": "templates/leviton_template.json#locator_led"
		}
	],
	"metadata": {
		"inclusion": "Classic Inclusion To A Z-Wave Network\nFor older controllers Classic Inclusion is supported. Depending on the age of the controller the controller will need to be 3 to 35 feet from the device when including.\n1. To enter programming mode, hold the button for 7 seconds. The status light will turn amber, release and the status light will blink.\n2. Follow the Z-Wave controller instructions to enter inclusion mode.\n3. Tap the top or the paddle of the paddle one time. The status light will quickly flash green.\n4. The Z-Wave controller will confirm successful inclusion to the network",
		"exclusion": "Exclusion From A Z-Wave Network\nWhen removing an fan speed controller from a Z-Wave network,\nbest practice is to use the exclusion command found in the Z-Wave\ncontroller.\n1. To enter programming mode, hold the button for 7 seconds. The\nstatus light will turn amber, release and the status light will blink.\n2. Follow Z-Wave controller directions to enter exclusion mode\n3. Tap the the top of the paddle 1 time. The status light will quickly\nflash green.\n4. The Z-Wave controller will remove the device from the network",
		"reset": "Factory Default\nWhen removing a fan speed controller from a network it is best\npractice to use the exclusion process. In situations where a device\nneeds to be returned to factory default follow the following steps. A\nreset should only be used when a controller is\ninoperable or missing.\n1. Hold the top of the paddle for 7 seconds, the status light will turn amber.\nContinue holding the top paddle for another 7 seconds (total of 14 seconds).\nThe status light will quickly flash red/ amber.\n2. Release the top of the paddle and the device will reset",
		"manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=product_documents/3832/Draft%20ZW4SF%203-25-20.pdf"
	}
}