{
	"manufacturer": "HomeSeer Technologies",
	"manufacturerId": "0x000c",
	"label": "HS-WV100+",
	"description": "Valve Controller",
	"devices": [
		{
			"productType": "0x0003",
			"productId": "0x0002",
			"zwaveAllianceId": 1845
		}
	],
	"firmwareVersion": {
		"min": "0.0",
		"max": "255.255"
	},
	"associations": {
		"1": {
			"label": "Lifeline",
			"maxNodes": 4,
			"isLifeline": true
		}
	},
	"metadata": {
		"inclusion": "How to Add the HS-WV100+ Z-Wave Valve Controller to your Z-Wave Controller\n- Plug the wall cube power adapter (included) into the receptacle on the bottom of the HS-WV100+ Z-Wave Valve Controller marked “3.6 VDC”. Plug the wall cube into a 110 VAC outlet. This provides power to the HS-WV100+ Z-Wave Valve Controller.\n- Configure the Z-Wave Controller to Add a device. \n- When the Z-Wave Controller is ready to add a device, it will display a message like “waiting to add device. Press Add button on the device”\n- The Add/Remove button is located on the side of the HS-WV100+ Z-Wave Valve Controller. Press the Add/Remove button.\n- The Z-Wave Controller will acknowledge that the HS-WV100+ Z-Wave Valve Controller had been added to the Z-Wave network.\n- Your HS-WV100+ Z-Wave Valve Controllerler is ready to use",
		"exclusion": "How to Remove the HS-WV100+ Z-Wave Valve Controllerler to your Z-Wave Controller\n\n- Plug the wall cube power adapter (included) into the receptacle on the bottom of the HS-WV100+ Z-Wave Valve Controller marked “3.6 VDC”. Plug the wall cube into a 110 VAC outlet. This provides power to the HS-WV100+ Z-Wave Valve Controller.\n- Configure the Z-Wave Controller to Remove a device. \n- When the Z-Wave Controller is ready to Remove a device, it will display a message like “waiting to remove device. Press remove button on the device”\n- The Add/Remove button is located on the side of the HS-WV100+ Z-Wave Valve Controller. Press the Add/Remove button. \n- The Z-Wave Controller will acknowledge that the HS-WV100+ Z-Wave Valve Controller had been removed from the Z-Wave network.\n- Your HS-WV100+ Z-Wave Valve Controller is removed form this controller",
		"reset": "How to reset the HS-WV100+ Z-Wave Valve Controller.\n- To reset the HS-WV100+ Z-Wave Valve Controller Z-Wave radio and routing table, press and hold the Add/Remove button located on the side of the HS-WV100+ Z-Wave Valve Control for 15 seconds. \n\nUse this procedure only when the network primary controller is missing or otherwise inoperable",
		"manual": "https://docs.homeseer.com/products/hs-wv100-user-guide"
	}
}