{ "manufacturer": "HomeSeer Technologies", "manufacturerId": "0x000c", "label": "HS-FLS100+", "description": "Floodlight Sensor", "devices": [ { "productType": "0x0201", "productId": "0x000b", "zwaveAllianceId": 2947 } ], "firmwareVersion": { "min": "0.0", "max": "255.255" }, "paramInformation": [ { "#": "1", "$import": "templates/homeseer_template.json#pir_trigger_off" }, { "#": "2", "label": "Light Level Threshold", "description": "Activate floodlight and send Basic Set Command when PIR is triggered while light level is below this threshold.", "valueSize": 2, "unit": "lux", "minValue": 0, "maxValue": 255, "defaultValue": 50, "options": [ { "label": "Never turn on floodlight", "value": 0 }, { "label": "Ignore light level", "value": 255 } ] }, { "#": "3", "$import": "templates/homeseer_template.json#multilevel_sensor_interval", "label": "Luminance Report Interval" }, { "#": "4", "$import": "~/templates/master_template.json#base_enable_disable", "label": "Send Basic Report On Trigger" } ], "compat": { "commandClasses": { "remove": { "Supervision": { // The device reports that it supports Supervision, but it does not support all // commands supervision-encapsulated "endpoints": "*" } } } }, "metadata": { "inclusion": "Z-Wave auto inclusion.\nOr manual inclusion : put the Z-Wave controller into inclusion mode, press the Link button 3 times within 1.5 seconds to put the unit into inclusion mode", "exclusion": "Put the Z-Wave Controller into exclusion mode. Press the Link button 3 times within 1.5 seconds to put the unit into exclusion mode", "reset": "The product reset is to operate only when the primary controller is missing or inoperable. Press the Link button 3 times within 1.5 seconds to put the unit into exclusion mode.Within 1 second of step 1, press the Link button again and hold until LED is off (about 5 seconds)", "manual": "https://products.z-wavealliance.org/ProductManual/File?folder=&filename=MarketCertificationFiles/2947/HS-FLS100-user-manual2b-A501112779R.pdf" } }